1 ############################################################################################################################
2 # Date: <22/08/2016> Version: <1.1> #
3 ############################################################################################################################
5 Feature: Attach Procedure With P-CSCF Address Request Indication in PCO
7 @attach-procedure @TS_24_301 @24_301_5_5 @24_301_5_5_1_2_2 @TS_24_368 @24_368_4 @24_368-5_4 @Series-0000
8 @TS_36_523_9_2_1_1_3 @Attach_Procedure_P-CSCF_Address_Request @PCO
10 Scenario: Attach Procedure indicating a request for P-CSCF address in the protocol configuration options
12 Given all configured endpoints for SSH are connected successfully
14 Given the steps below will be executed at the end
15 When I stop S1AP simulator on node ABOT
16 When I run the SSH command "sudo service mme_gw restart" on node MME
17 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
18 Then the ending steps are complete
20 # Set ABOT configuration
21 Given that I setup S1AP Simulator with default parameters specified in {abotprop.ABOT.EPC.Defaults} on node ABOT
22 Given that I setup S1AP Simulator with USIM parameter "ABOT.UE.USIM.AttachWithImsi=true" on node ABOT
24 Given that I setup S1AP Simulator with UE parameter "ABOT.UE.CONFIG.PCO.IPV6_P_CSCF_ADDR_REQ=true" on node ABOT
26 # Execute ABOT S1AP Simulator
27 When I run S1AP simulator on node ABOT with 1 UE
29 # Wait for execution to complete before checking results
30 Given the execution is paused for {abotprop.WAIT_10_SEC} seconds
32 # Validate Test Case Execution at Simulator
33 Then I receive S1AP response on node ABOT and verify the presence of all the following values:
34 | responseResult | existence |
35 | Send Attach Request message with IMSI | {string:nocase:present} |
36 | Send PDN Connectivity Request message with P-CSCF Address Request | {string:nocase:present} |
37 | Received Authentication Request message | {string:nocase:present} |
38 | Send Authentication Response message | {string:nocase:present} |
39 | Received Authentication Request message | {string:nocase:present} |
40 | Send Authentication Response message | {string:nocase:present} |
41 | Received Security Mode Command message | {string:nocase:present} |
42 | Send Security Mode Complete message | {string:nocase:present} |
43 | Received Attach Accept message | {string:nocase:present} |
44 | Received Activate Default EPS Bearer Context Request message with PCO contain Protocol ID 0001 | {string:nocase:present} |