1 .. This work is licensed under a Creative Commons Attribution 4.0 International
3 .. http://creativecommons.org/licenses/by/4.0
4 .. (c) OPNFV, 2017 Intel Corporation.
6 ************************************************
7 Yardstick Test Case Description: NSB PROX LwAFTR
8 ************************************************
10 +-----------------------------------------------------------------------------+
11 |NSB PROX test for NFVI characterization |
13 +--------------+--------------------------------------------------------------+
14 |test case id | tc_prox_{context}_lw_aftr-{port_num} |
16 | | * context = baremetal or heat_context; |
19 +--------------+--------------------------------------------------------------+
20 |metric | * Network Throughput; |
21 | | * TG Packets Out; |
22 | | * TG Packets In; |
23 | | * VNF Packets Out; |
24 | | * VNF Packets In; |
25 | | * Dropped packets; |
27 +--------------+--------------------------------------------------------------+
28 |test purpose | The PROX LW_AFTR test will take packets in from one |
29 | | port and remove the ipv6 encapsulation and forward them to |
30 | | another port. While forwarded packets in other direction |
31 | | will be encapsulated in an ipv6 header. |
33 | | The lw_aftr test cases are implemented to run in baremetal |
34 | | and heat context an require 4 port topology to run the |
35 | | default configuration. |
37 +--------------+--------------------------------------------------------------+
38 |configuration | The LW_AFTR test cases are listed below: |
40 | | * tc_prox_baremetal_lw_aftr-4.yaml |
41 | | * tc_prox_heat_context_lw_aftr-4.yaml |
43 | | Test duration is set as 300sec for each test. |
44 | | The minimum packet size for MPLS test is 68 bytes. This is |
45 | | set in the traffic profile and can be configured to use |
46 | | higher packet sizes. |
48 +--------------+--------------------------------------------------------------+
50 | | PROX is a DPDK application that can simulate VNF workloads |
51 | | and can generate traffic and used for NFVI characterization |
53 +--------------+--------------------------------------------------------------+
54 |applicability | The PROX lwAFTR test cases can be configured with |
58 | | * test durations; |
59 | | * tolerated loss; |
61 | | Default values exist. |
63 +--------------+--------------------------------------------------------------+
64 |pre-test | For Openstack test case image (yardstick-samplevnfs) needs |
65 |conditions | to be installed into Glance with Prox and Dpdk included in |
68 | | For Baremetal tests cases Prox and Dpdk must be installed in |
69 | | the hosts where the test is executed. The pod.yaml file must |
70 | | have the necessary system and NIC information |
72 +--------------+--------------------------------------------------------------+
73 |test sequence | description and expected result |
75 +--------------+--------------------------------------------------------------+
76 |step 1 | For Baremetal test: The TG and VNF are started on the hosts |
77 | | based on the pod file. |
79 | | For Heat test: Two host VMs are booted, as Traffic generator |
80 | | and VNF(LW_AFTR workload) based on the test flavor. |
82 +--------------+--------------------------------------------------------------+
83 |step 2 | Yardstick is connected with the TG and VNF by using ssh. |
84 | | The test will resolve the topology and instantiate the VNF |
85 | | and TG and collect the KPI's/metrics. |
87 +--------------+--------------------------------------------------------------+
88 |step 3 | The TG will send packets to the VNF. If the number of |
89 | | dropped packets is more than the tolerated loss the line |
90 | | rate or throughput is halved. This is done until the dropped |
91 | | packets are within an acceptable tolerated loss. |
93 | | The KPI is the number of packets per second for 86 bytes |
94 | | packet size with an accepted minimal packet loss for the |
95 | | default configuration. |
97 +--------------+--------------------------------------------------------------+
98 |step 4 | In Baremetal test: The test quits the application and unbind |
101 | | In Heat test: Two host VMs are deleted on test completion. |
103 +--------------+--------------------------------------------------------------+
104 |test verdict | The test case will achieve a Throughput with an accepted |
105 | | minimal tolerated packet loss. |
106 +--------------+--------------------------------------------------------------+